Home › Engine / Hybrid System › 1GR-FE (INTAKE / EXHAUST) › INTAKE MANIFOLD › 2014.08–2022.09
RM25T0E _51 Engine / Hybrid System _029771 1GR-FE INTAKE / EXHAUST _0135414 INTAKE MANIFOLD A

1GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17705 5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

a.
A331850

Detach the clamp and disconnect the mass air flow meter connector.


b.
A331851

Disconnect the vacuum hose from the No. 1 air cleaner hose.


c.

Slide the clamp and disconnect the No. 2 ventilation hose from the No. 1 air cleaner hose.


d.

Detach the clamp and disconnect the wire harness.


e.

Remove the bolt.


f.
A331852

Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the cylinder head cover sub-assembly.


g.

Detach the 3 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.


Hide 17129 6.REMOVE INTAKE AIR SURGE TANK

a.
A151856

Disconnect the throttle body connector.


b.

Slide the clamp and disconnect the No. 4 water by-pass hose from the water inlet housing.


c.

Slide the clamp and disconnect the No. 5 water by-pass hose from the water inlet housing.


d.
A178934

Slide the clamp and disconnect the No. 1 fuel vapor feed hose from the No. 1 vacuum switching valve assembly.


e.

Disconnect the No. 1 vacuum switching valve connector.


f.

Slide the clamp and disconnect the No. 1 ventilation hose from the intake air surge tank.


g.
A218347

Disconnect the vacuum switching valve (for ACIS) connector.


h.
A151767

Remove the 2 bolts and throttle body bracket.


i.
A178935

Using a clip remover, detach the wire harness clamp from the No. 1 surge tank stay.


j.
A218319

Remove the bolt and disconnect the ground wire from the No. 1 surge tank stay.


k.

Remove the bolt and disconnect the engine oil level dipstick guide from the No. 1 surge tank stay.


l.

Remove the bolt and oil baffle plate.


m.

Remove the 2 bolts and No. 1 surge tank stay.


n.
A218333

Detach the wire harness clamp.


o.
A218328

Remove the 2 nuts and disconnect the clutch hose bracket.


p.

Remove the 2 bolts and No. 2 surge tank stay.


q.
A326469

Remove the 2 nuts.


r.

Using an 8 mm hexagon wrench, remove the 4 bolts. Then remove the intake air surge tank and gasket.


Hide 23801P 7.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 23802B 8.REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23807 9.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A151776

Remove the 10 bolts, intake manifold and 2 gaskets.