Use these procedures to troubleshoot the anti-lock brake system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer and confirm the trouble.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
| Proceed to |
|---|
| NEXT |
NEXT
Check and record output DTCs and the freeze frame data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
Clear the DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
Reconfirm the DTC.
Reconfirm the DTC based on the recorded DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC output |
| DTC is not output (Problem symptom does not occur) |
| DTC is not output (Problem symptom occurs) |
DTC output
DTC is not output (Problem symptom does not occur)
DTC is not output (Problem symptom occurs)
Proceed to Diagnostic Trouble Code Chart.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to Symptom Simulation (How to Proceed with Troubleshooting)
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to Problem Symptoms Table.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT