Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0135612 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  TS and CG Terminal Circuit  


DESCRIPTION

The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.

HINT:

Change to Test Mode (signal check) by connecting terminals TS and CG of the DLC3, and turning the ignition switch from off to ON.


WIRING DIAGRAM

C237134E24
5.479,1.833 5.958,2.083 0.479,0.25 10 false A20 5.479,2 7.063,2.552 1.583,0.552 10 false Brake Actuator Assembly (Skid Control ECU) 5.865,0.563 6.344,0.823 0.479,0.26 10 false TS 0.917,0.542 1.417,0.823 0.5,0.281 10 false TS 0.906,1.125 1.323,1.365 0.417,0.24 10 false CG 0.583,1.844 1.229,2.229 0.646,0.385 10 false I17 0.594,2.01 1.24,2.24 0.646,0.229 10 false DLC3 5.51,0.458 5.76,0.667 0.25,0.208 10 false 32 1.281,0.438 1.542,0.667 0.26,0.229 10 false 12 1.292,1.021 1.552,1.25 0.26,0.229 10 false 4

CAUTION / NOTICE / HINT

NOTICE:
·

Before disconnecting the connector, make sure that there are no problems with the connection.

·

After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - BRAKE ACTUATOR ASSEMBLY)
a.

Turn the ignition switch off.


b.

Disconnect the A20 brake actuator assembly (skid control ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I17-4 (CG) - Body ground Always Below 1 Ω
I17-12 (TS) - A20-32 (TS) Always Below 1 Ω
I17-12 (TS) or A20-32 (TS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR