1. PRECAUTION
After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery teminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4.DRAIN FUEL
Loosen the fuel tank drain plug and drain the fuel from the fuel sub tank.
Install a new gasket and the fuel tank drain plug to the fuel sub tank.
5.DISCONNECT FUEL MAIN HOSE
Disconnect the fuel main hose from the fuel suction tube sub-assembly.
Click hereEngine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION
6.DISCONNECT FUEL RETURN HOSE
Slide the clamp and disconnect the fuel return hose from the fuel suction tube sub-assembly.
77213 7.DISCONNECT FUEL INLET HOSE
Loosen the clamp and disconnect the fuel inlet hose from the fuel tank filler lower pipe sub-assembly.
77100D 8.DISCONNECT FUEL BREATHER HOSE
Slide the clamp and disconnect the fuel breather hose from the fuel sub tank.
9.REMOVE FUEL SUB TANK
Disconnect the fuel pump connector and sender gauge connector and detach the wire harness clamp.
Set an engine lifter underneath the fuel sub tank.
Remove the 2 bolts, 2 pins and disconnect the 2 fuel tank bands.
Slightly lower the engine lifter.
Remove the No. 1 fuel tank protector sub-assembly.
83320 10.REMOVE FUEL SENDER GAUGE ASSEMBLY
77203B 11.REMOVE FUEL SUCTION TUBE SUB-ASSEMBLY
Remove the nut.
Remove the 7 screws and fuel suction tube sub-assembly from the fuel sub tank.
Remove the gasket from the fuel suction tube sub-assembly.
77011 12.REMOVE FUEL TANK FILLER LOWER PIPE SUB-ASSEMBLY
Remove the 6 screws and fuel tank filler lower pipe sub-assembly from the fuel sub tank.
Remove the gasket from the fuel tank filler lower pipe sub-assembly.