31250 1.REMOVE CLUTCH DISC ASSEMBLY
13405 2.REMOVE FLYWHEEL SUB-ASSEMBLY
11381A 3.REMOVE ENGINE REAR OIL SEAL
| *a | Cut Position |
| *b | Protective Tape |
Using a knife, cut off the lip of the engine rear oil seal.
Using a screwdriver, pry out the engine rear oil seal.
Tape the screwdriver tip before use.
Be careful not to damage the crankshaft.
After removing the engine rear oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.