Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER (for LHD) › 2014.08–2017.01
RM25T0E _52 Drivetrain _029901 CLUTCH _0136566 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  INSTALLATION  


PROCEDURE

Hide 31434 1.CONNECT CLUTCH RESERVOIR TUBE

Hide 31410 2.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.
C310585C01
0,0 0,0 false
V100136

MP grease


Install the clutch master cylinder assembly with the 2 bolts.

Torque:
11.8 N*m (120 kgf*cm, 9 ft.*lbf)


b.

Apply MP grease to the contact surface of the clutch master cylinder push rod clevis pin.


c.

Install the wave washer to the clutch master cylinder push rod clevis pin.


d.

Connect the clevis of the master cylinder to the clutch pedal with the clutch master cylinder push rod clevis pin.


e.

Install a new clip to the clutch master cylinder push rod clevis pin.


Hide 31301A 3.INSTALL CLUTCH PEDAL SPRING (for 1GR-FE)

Hide 31301R 4.INSTALL TURN OVER SPRING SEAT COMPRESSION SPRING

Hide 31481J 5.CONNECT CLUTCH MASTER CYLINDER TO 2 WAY TUBE

a.
C310601C01
0.417,1.354 0.729,1.552 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the clutch master cylinder to 2 way tube to the clutch master cylinder assembly.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 300 mm (11.811 in.)): 14.2 N*m (145 kgf*cm, 10 ft.*lbf)




Hide 6.FILL RESERVOIR WITH BRAKE FLUID

Hide 7.BLEED CLUTCH PIPE LINE

Hide 8.CHECK BRAKE FLUID LEVEL IN RESERVOIR

Hide 9.CHECK FOR CLUTCH FLUID LEAK

Hide 31301 10.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY