31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
Install a new gasket.
Install the clutch master cylinder assembly with the 2 nuts.
|
MP grease |
Apply MP grease to the contact surface of the clutch master cylinder push rod clevis pin.
Connect the clevis of the master cylinder to the clutch pedal with the clutch master cylinder push rod clevis pin.
Install a new clip to the clutch master cylinder push rod clevis pin.
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the clutch master cylinder to flexible hose tube.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 300 mm (11.811 in.)): 14.2 N*m (145 kgf*cm, 10 ft.*lbf)
2.FILL RESERVOIR WITH BRAKE FLUID
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
3.BLEED CLUTCH PIPE LINE
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
4.CHECK FLUID LEVEL IN RESERVOIR
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
31426 5.INSTALL CLUTCH MASTER CYLINDER RESERVOIR FLOAT
31440P 6.INSTALL CLUTCH MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
7.CHECK FOR CLUTCH FLUID LEAK
31301 8.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY