Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
45100 2.REMOVE STEERING WHEEL ASSEMBLY
45287 3.REMOVE LOWER STEERING COLUMN COVER
Operate the steering tilt lever to lower and extend the steering column assembly.
Remove the 2 screws.
Detach the 2 claws to remove the lower steering column cover.
45286B 4.REMOVE UPPER STEERING COLUMN COVER
Detach the claw to remove the upper steering column cover.
84306 5.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors.
Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.
55480D 6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55844 7.REMOVE NO. 2 HEATER TO REGISTER DUCT
Remove the clip and No. 2 heater to register duct.
8.REMOVE STEERING COLUMN ASSEMBLY
| *a | Matchmark |
Put matchmarks on the steering intermediate shaft assembly and steering column assembly.
Remove the bolt.
Detach the wire harness 2 clamps from the steering column assembly.
Remove the 2 nuts, bolt and steering column assembly.