Home › Engine / Hybrid System › 1HZ (STARTING) › GLOW PLUG
RM25T0E _51 Engine / Hybrid System _029899 1HZ STARTING _0136994 GLOW PLUG G

1HZ STARTING  GLOW PLUG  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 19850 1.INSPECT GLOW PLUG ASSEMBLY

a.

Remove the No. 1 glow plug connector.

Click hereEngine / Hybrid System>1HZ (STARTING)>GLOW PLUG>REMOVAL


b.
A326088

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Glow plug terminal - Ground 20°C (68°F) Approximately 1.0 Ω


NOTICE:
·

Do not damage the glow plug pipes as this could cause an open circuit or shorten the life of the glow plug assemblies.

·

Prevent oil and fuel from spraying onto the glow plug assemblies when cleaning.

·

Wipe any oil off the terminal and Bakelite washer with a dry cloth if they are stained with oil during the inspection.



If the result is not as specified, replace the glow plug assembly.


c.

Install the No. 1 glow plug connector.

Click hereEngine / Hybrid System>1HZ (STARTING)>GLOW PLUG>INSTALLATION