Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT FENDER WHEEL MOULDING
RM25T0E _59 Vehicle Exterior _029942 EXTERIOR PANELS / TRIM _0137751 FRONT FENDER WHEEL MOULDING A

EXTERIOR PANELS / TRIM  FRONT FENDER WHEEL MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 76604 1.REMOVE FRONT FENDER MUDGUARD SUB-ASSEMBLY LH

Hide 53088A 2.REMOVE FRONT WHEEL OPENING EXTENSION SUB-ASSEMBLY LH

a.
B167411C01
2.708,2.698 2.708,3.042 2.708,3.042 3.01,3.042 false 3.042,2.958 3.302,3.177 0.26,0.219 10 false *1
*1 Grommet


Remove the 3 screws.


b.

Remove the grommet.


c.
B388370N01
2.563,1.865 2.771,2.135 0.208,0.271 10 false A

Put a 4 mm (0.157 in.) drill bit into a drill.


d.

Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill as shown in the illustration.

HINT:

Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.


Standard:
Area Specified Condition
A 5 mm (0.197 in.)



e.

Lightly press the drill against the 2 rivets and drill off the flanges of the 2 rivets.

CAUTION:

Be careful of the drilled rivet as it may become hot.


NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.




f.

Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.


g.
B171901

Detach the 8 clips and remove the front wheel opening extension sub-assembly LH.


h.

Remove the clips from the front wheel opening extension sub-assembly LH.


Hide 53851C 3.REMOVE FRONT WHEEL NO. 1 OPENING MOULDING PAD

a.
B384477

Remove the Front No. 1 wheel opening moulding pad.


Hide 53861 4.REMOVE FRONT WHEEL NO. 1 OPENING BRACKET

a.
B168227

Remove the 2 screws and front wheel No. 1 opening bracket.


Hide 53862 5.REMOVE FRONT WHEEL NO. 2 OPENING BRACKET

a.
B168229

Remove the 2 screws and front wheel No. 2 opening bracket.


Hide 53865 6.REMOVE FRONT WHEEL NO. 3 OPENING BRACKET

a.
B168230

Remove the 2 screws and front wheel No. 3 opening bracket.