1.ADJUST COMPRESSOR OIL
When replacing the compressor assembly with magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor assembly with magnet clutch before installation.
(Oil capacity inside the new compressor assembly with magnet clutch: 120 + 15 cc (4.06 + 0.51 fl.oz.)) - (Remaining oil amount in the removed compressor assembly with magnet clutch) = (Oil amount to be removed from the new compressor when replacing)
When checking the compressor oil level, follow the A/C system's precautions.
If a new compressor assembly with magnet clutch is installed without removing some oil remaining in the pipes of the vehicle, the oil amount will be too large. This prevents heat exchange in the refrigerant cycle and causes refrigerant failure.
If the volume of oil remaining in the removed compressor assembly with magnet clutch is too small, check for oil leakage.
Be sure to use ND-OIL 8 or equivalent for compressor oil.
2.INSTALL COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH
Install the compressor assembly with magnet clutch with the 4 bolts.
88712 3.CONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE
Remove the attached vinyl tape from the No. 1 cooler refrigerant suction hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor assembly with magnet clutch.
ND-OIL 8 or equivalent
Install the O-ring on the No. 1 cooler refrigerant suction hose.
Connect the No. 1 cooler refrigerant suction hose on the compressor assembly with magnet clutch with the bolt.
88711 4.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the attached vinyl tape from the No. 1 cooler refrigerant discharge hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor assembly with magnet clutch.
ND-OIL 8 or equivalent
Install the O-ring on the No. 1 cooler refrigerant discharge hose.
Connect the No. 1 cooler refrigerant discharge hose on the compressor assembly with magnet clutch with the bolt.
88310A 5.INSTALL NO. 1 V BELT
6.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
7.WARM UP ENGINE
8.CHECK FOR REFRIGERANT GAS LEAK