Use the same procedure for LHD and RHD vehicles.
The procedures listed below are for LHD vehicles.
55480D 1.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55411G 2.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
55421B 3.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL
83100 4.REMOVE COMBINATION METER ASSEMBLY
55409F 5.REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
55446A 6.REMOVE NO. 1 SWITCH HOLE BASE
55412D 7.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL
86120 8.REMOVE RADIO RECEIVER ASSEMBLY
86101 9.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o USB Audio System)
Disconnect the connector.
Detach the 6 clamps and remove the antenna cord sub-assembly.
86101 10.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ USB Audio System)
Disconnect the connector.
Detach the 6 clamps and remove the antenna cord sub-assembly.