Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2014.08–2021.07
RM25T0E _58 Vehicle Interior _029929 SUPPLEMENTAL RESTRAINT SYSTEMS _0138000 FRONT PASSENGER AIRBAG ASSEMBLY N

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  DISPOSAL  


CAUTION / NOTICE / HINT

CAUTION:
·

An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with bare hands to discharge static electricity before performing this procedure.

·

Never dispose of an instrument panel passenger airbag assembly with an undeployed airbag.

·

The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a nuisance to nearby residents.

·

When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away from electrical noise.

·

When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the instrument panel passenger airbag assembly.

·

The instrument panel passenger airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

·

Use gloves and safety glasses when handling an instrument panel passenger airbag assembly with a deployed airbag.

·

Do not apply water to an instrument panel passenger airbag assembly with a deployed airbag.

·

Always wash your hands with water after completing the operation.



HINT:

When scrapping a vehicle equipped with the SRS or disposing of the steering pad, be sure to deploy the airbag first in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the SERVICE DEPT. of DISTRIBUTOR.


PROCEDURE

Hide 73970A 1.DISPOSE OF INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE)

NOTICE:
·

When disposing of the instrument panel passenger airbag assembly, use an unneeded vehicle to deploy the airbag.

·

Be sure to observe the following procedure when deploying the airbag.



HINT:

Prepare a battery as the power source to deploy the airbag.


a.
C110371N26
0.875,1.208 0.833,0.635 0.833,0.635 0.646,0.635 false 0.365,0.563 0.823,0.76 0.458,0.198 10 SST

Check the function of SST.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>DISPOSAL

SST
09082-00700  


b.

Read the precaution.


c.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



d.

Remove the glove compartment door assembly.


e.
B374342C01
0.74,2.563 0.833,2.281 0.833,2.281 1.073,2.281 true 1.135,2.167 1.448,2.323 0.313,0.156 10 false *1
*1 Slider


Slide the slider to release the lock, and then disconnect the airbag connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



f.

Install SST.

i.
B234329N01
2.125,0.219 1.594,0.219 1.594,0.219 1.594,1.563 true 2.313,1.146 1.979,0.219 true 2.198,0.115 2.521,0.313 0.323,0.198 10 true SST

Connect SST connector to the instrument panel wire.

NOTICE:

To avoid damaging the SST connector or wire harness, do not lock the secondary lock of the twin lock.


SST
09082-00700  09082-00780  


ii.
B340835C02
0.729,1.521 0.646,0.917 0.646,0.917 0.521,0.917 false 1.604,1.896 1.917,2.052 0.313,0.156 10 false *a 0.208,0.844 0.667,1.042 0.458,0.198 10 false SST
*a 10 m or more


Move SST at least 10 m (32.8 ft.) away from the vehicle front side window.


iii.

While maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.

NOTICE:

Take care not to damage SST wire harness.



iv.

Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the negative (-) terminal.



g.

Deploy the airbag.

i.

Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.


ii.

Press SST activation switch to deploy the airbag.

CAUTION:

Before deployment, make sure that no one is near the vehicle.


HINT:

The airbag is deployed as the LED of SST activation switch comes on.




h.

Remove the instrument panel passenger airbag assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>FRONT PASSENGER AIRBAG ASSEMBLY>REMOVAL

CAUTION:
·

The instrument panel passenger airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

·

Use gloves and safety glasses when handling an instrument panel passenger airbag assembly with a deployed airbag.

·

Do not apply water etc. to an instrument panel passenger airbag assembly with a deployed airbag.

·

After removal, quickly seal the instrument panel passenger airbag assembly in a plastic bag.

·

Always wash your hands with water after completing the operation.




Hide 73970A 2.DISPOSE OF INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)

NOTICE:

Be sure to follow the procedure detailed below when deploying the airbag.


HINT:

Prepare a battery as the power source to deploy the airbag.


a.
C110371N26
0.875,1.208 0.833,0.635 0.833,0.635 0.646,0.635 false 0.365,0.563 0.823,0.76 0.458,0.198 10 SST

Check the function of SST.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>DISPOSAL

SST
09082-00700  


b.

Remove the instrument panel passenger airbag assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>FRONT PASSENGER AIRBAG ASSEMBLY>REMOVAL

CAUTION:
·

Before removing the instrument panel passenger airbag assembly, wait at least 90 seconds after turning the ignition switch off and disconnecting the cable from the negative (-) battery terminal.

·

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.




c.

Install SST.

i.
B234330N01
1.896,1.854 2.542,1.854 false 2.594,1.76 2.885,1.938 0.292,0.177 10 false SST

After connecting the following SST to each other, connect them to the instrument panel passenger airbag assembly.

SST
09082-00802  (09082-10801, 09082-40800)



d.
B104882C54
1.99,1.594 1.99,1.25 false 2.656,0.51 2.969,0.667 0.313,0.156 10 *a 1.917,1.625 2.229,1.781 0.313,0.156 10 *b
*a Wire Diameter
*b Stripped Wire Section


Using braided wire, tie down the instrument panel passenger airbag assembly to an unneeded tire.

Wire:
Cross-sectional area of stripped wire:

1.25 mm2 (0.00192 in.2) or more


CAUTION:

If the wire harness is too thin or an alternative object is used to tie down the instrument panel passenger airbag, it may be snapped by the shock when the airbag is deployed. Always use a wire harness for vehicle use with a cross-sectional area of at least 1.25 mm2 (0.0019 in.2).


HINT:

To calculate the area of the cross-sectional area of stripped wire: Area = 3.14 x (Diameter)2 / 4


i.

Position the instrument panel passenger airbag assembly inside a tire with the airbag deployment side facing inside.

Tire size:

Must exceed the following dimensions

Width:

185 mm (7.28 in.)

Inner diameter:

360 mm (14.2 in.)


CAUTION:
·

Make sure that the wire harnesses are tight. If there is slack in the wires, the instrument panel passenger airbag assembly may break loose when the airbag is deployed.

·

Always tie down the instrument panel passenger airbag assembly with the airbag deployment side facing inside of the tire.



NOTICE:

The tires may be damaged by the airbag deployment, so use unneeded tires.


B234331C01
0.698,0.885 1.063,0.885 1.063,0.885 1.448,2.208 true 0.521,0.781 0.833,0.938 0.313,0.156 10 false *a 0.74,3.365 1.052,3.521 0.313,0.156 10 false *b 3.208,2.615 3.521,2.771 0.313,0.156 10 false *c
*a Deployment Side *b Width
*c Inner Diameter - -




e.
B234332C01
2.344,0.469 2.656,0.625 0.313,0.156 10 false *1 2.354,1.531 2.667,1.688 0.313,0.156 10 false *1
*1 Tires (2 or more)


Place tires.

i.

Place at least 2 tires under the tire to which the instrument panel passenger airbag assembly is tied.


ii.

Place at least 2 tires onto the tire to which the instrument panel passenger airbag assembly is tied. The top tire should have a wheel installed.

NOTICE:
·

Do not place SST connector under the tire because it could be damaged.

·

The tires and wheel may be damaged by the airbag deployment, so use unneeded tires and wheels.




iii.
B105087

Tie the tires together with 2 wire harnesses.

CAUTION:

Make sure that the wires are tight. Looseness in the wires results in the tires breaking loose when the airbag is deployed.




f.
B234333C01
1.208,2.719 1.208,2.427 1.208,2.427 1.563,2.427 false 1.625,2.344 2.042,2.542 0.417,0.198 10 false SST 1.313,2.958 1.625,3.156 0.313,0.198 10 false *a
*a 10 m or more


Install SST.

i.

Connect SST connector.

SST
09082-00700  

NOTICE:

To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock. Also, secure some slack for SST wire harness inside the tire.




g.

Deploy the airbag.

i.

Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.


ii.

Check that no one is within a 10 m (32.8 ft.) radius of the wheel to which the instrument panel passenger airbag assembly is tied.


iii.

Press SST activation switch to deploy the airbag.

CAUTION:

Before deployment, make sure that no one is near the airbag.


HINT:

The airbag is deployed as the LED of SST activation switch comes on.




h.
B234334

Dispose of the instrument panel passenger airbag assembly.

CAUTION:
·

The instrument panel passenger airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

·

Use gloves and safety glasses when handling an instrument panel passenger airbag assembly with a deployed airbag.

·

Do not apply water etc. to an instrument panel passenger airbag assembly with a deployed airbag.

·

Always wash your hands with water after completing the operation.



i.

Remove the instrument panel passenger airbag assembly from the tire.


ii.

Place the instrument panel passenger airbag assembly in a plastic bag, tie it tightly and dispose of it according to local regulations.