A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
87120 1.INSTALL REAR HEATER ASSEMBLY
Install the rear heater assembly with the 4 bolts.
Connect the connector.
87255F 2.CONNECT HEATER UNIT REAR HEATER WATER INLET HOSE
| *a | View A |
| *b | Clip Installation Angle |
| *c | Upper Side |
| *d | Front Side |
Connect the heater unit rear heater water inlet hose with the paint mark (white) facing up and attach the clip within the area shown in the illustration.
Do not apply excessive force to the heater unit rear heater water inlet hose.
87256F 3.CONNECT HEATER UNIT REAR HEATER WATER OUTLET HOSE
| *a | View A |
| *b | Clip Installation Angle |
| *c | Upper Side |
| *d | Front Side |
Connect the heater unit rear heater water outlet hose with the paint mark (White) facing up and attach the clip within the area shown in the illustration.
Do not apply excessive force to the heater unit rear heater water outlet hose.
62588A 4.INSTALL SIDE HEATER LOWER COVER
Install the side heater lower cover with the 6 clips.
87123 5.INSTALL HEATER KNOB
Install the heater knob.
87125A 6.INSTALL AIR OUTLET GRILLE
Install the air outlet grille with the 2 screws.
62511 7.INSTALL QUARTER INSIDE TRIM BOARD RH
Install the quarter inside trim board RH with the 11 clips.
73298 8.INSTALL NO. 2 QUARTER TRIM BELT HOLE COVER RH (w/ Rear No. 2 Seat)
Install the No. 2 quarter trim belt hole cover with the 2 screws.
73297B 9.INSTALL QUARTER TRIM BELT HOLE COVER RH
Install the quarter trim belt hole cover RH with the 2 screws.
58796A 10.INSTALL JACK CLAMP HOOK
Install the jack clamp hook with the 2 bolts.
09116 11.INSTALL JACK HANDLE LEVER
Install the jack handle lever.
09115 12.INSTALL JACK HANDLE ROD SUB-ASSEMBLY
13.INSTALL REAR SIDE SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
14.INSTALL REAR NO. 1 SEAT ASSEMBLY (w/o Rear No. 2 Seat)
15.ADD ENGINE COOLANT
16. WARM UP ENGINE
17.INSPECT FOR COOLANT LEAK