Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.INSTALL QUARTER WINDOW GLASS
Temporarily install the quarter window glass with the 2 screws and 4 nuts.
Perform a gap check.
Check the gap between the quarter panel and quarter window glass.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| a | 13.4 mm (0.5276 in.) | b | 20.7 mm (0.8150 in.) |
| c | 20.0 mm (0.7874 in.) | - | - |
Tighten the 2 screws and 4 nuts.
2.CHECK FOR LEAKS AND REPAIR
Spray water on the vehicle. Check that no water leaks into the vehicle. If water leaks into the vehicle, perform the adjustment again.
62584A 3.INSTALL UPPER QUARTER PILLAR COVER LH
Attach the 4 claws and 3 clips to install the upper quarter pillar cover LH.
73370 4.CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
Install the seat belt shoulder anchor with the bolt.
Attach the 2 claws to close the seat belt anchor cover.
62334A 5.INSTALL REAR DOOR OPENING TRIM LH
62512 6.INSTALL QUARTER INSIDE TRIM BOARD
Refer to the procedures from "QUARTER INSIDE TRIM BOARD LH" (see page Audio / Visual / Telematics>AUDIO / VIDEO>QUARTER TRIM SPEAKER(for 5 Door)>INSTALLATION).
Refer to the procedures from "QUARTER INSIDE TRIM BOARD RH" (see page Audio / Visual / Telematics>AUDIO / VIDEO>QUARTER TRIM SPEAKER(for 5 Door)>INSTALLATION).
64707D 7.INSTALL QUARTER TRIM JACK COVER SUB-ASSEMBLY
62552F 8.INSTALL REAR SEAT SIDE GARNISH LH
67918A 9.INSTALL REAR DOOR SCUFF PLATE LH