DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are communicated through SRS warning light blinking patterns.
When one or more of the warning lights blink continuously, the cause may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in an ECU.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the I51 connector from the airbag sensor assembly.
| *a | Front view of DLC3 |
| *b | Rear view of wire harness connector (to Airbag Sensor Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-13 (TC) - I51-12 (TC) | Always | Below 1 Ω |
| I17-4 (CG) - Body ground | Always | Below 1 Ω |
| I51-12 (TC) - Body ground | Always | 1 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG