A maximum of 5 master key ID codes and 3 sub key ID codes can be registered.
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
Check that the system enters registration mode.
System enters registration mode.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
In registration mode, insert the key into the ignition key cylinder and check the security indicator light.
If the new key ID code registration fails, code 2-1 will be output through the security light. Trying to re-register an already registered key will cause code 2-2 to be output when the key is inserted. If the number of registered key ID codes exceeds the maximum limit, code 2-3 will be output through the security indicator light. The output details are shown in the following illustration.
| *a | Security Indicator Light | *b | Normal (Immobiliser system is operating normally) |
| *c | Code 2-1 | *d | Code 2-2 |
| *e | Code 2-3 | - | - |
| Result | Proceed to |
|---|---|
| Code 2-1 or Code 2-3 is output | A |
| Code 2-2 is output | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Transponder S-code | Number of registered sub key | min. 0, max. 15 | Number of registered sub keys displayed | - |
| Transponder M-code | Number of registered master key | min. 0, max. 15 | Number of registered master keys displayed | - |
| Tester Display |
|---|
| Transponder S-code |
| Transponder M-code |
| Result | Proceed to |
|---|---|
| 5 is displayed for "Transponder M-code" and 0 is displayed for "Transponder S-code" | A |
| 0 is displayed for "Transponder M-code" and 3 is displayed for "Transponder S-code" | B |
| 5 is displayed for "Transponder M-code" and 3 is displayed for "Transponder S-code" | C |
| Values are other than above | D |
A
B
C
D
Refer to the table below to determine if additional keys can be registered.
| Number of Door control transmitter assemblies Registered (Master and Sub) | Proceed to |
|---|---|
| 0 | New key ID code registration |
| 1 to 7 | Additional key ID code registration |
Check if an additional key can be registered.
Additional key can be registered.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL
Inspect the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the L20 unlock warning switch assembly connector.
Disconnect the L30 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L20-2 - L30-3 (KSW) | Always | Below 1 Ω |
| L20-1 - Body ground | Always | Below 1 Ω |
| L20-2 or L30-3 (KSW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG