Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
47201 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER(w/ ABS)>REMOVAL
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER (w/o ABS)>REMOVAL
44773F 3.REMOVE UNION TO CHECK VALVE HOSE
Slide the clip and disconnect the hose.
47101A 4.REMOVE BRAKE PEDAL RETURN SPRING
47264A 5.REMOVE PUSH ROD PIN
47264D 6.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Loosen the push rod clevis lock nut.
Remove the push rod clevis.
44610 7.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts.
Pull out the brake booster with the brake booster gasket.
44735C 8.REMOVE BOOSTER BRACKET STOPPER RING
Remove the 2 stopper rings from the brake booster.
44731C 9.REMOVE BRAKE BOOSTER BRACKET
44785 10.REMOVE BRAKE BOOSTER GASKET
44730 11.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY (for 1GR-FE)
Remove the brake vacuum check valve assembly from the brake booster.
44696 12.REMOVE CHECK VALVE GROMMET (for 1GR-FE)
Remove the check valve grommet from the brake booster.