Home › Brake › BRAKE SYSTEM (OTHER) › LOAD SENSING PROPORTIONING VALVE › 2014.08–2017.09
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0138397 LOAD SENSING PROPORTIONING VALVE A

BRAKE SYSTEM (OTHER)  LOAD SENSING PROPORTIONING VALVE  INSTALLATION  


PROCEDURE

Hide 47932A 1.INSTALL LOAD SENSING VALVE UNION BRACKET

a.

Install the load sensing valve union bracket with the 4 bolts.

Torque:
25.5 N*m (260 kgf*cm, 19 ft.*lbf)


Hide 2.INSTALL LOAD SENSING PROPORTIONING VALVE

a.

Install the load sensing proportioning valve with the 4 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


b.

Install the No. 1 load sensing shackle bracket to the rear axle housing with the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 3.CONNECT BRAKE TUBE

a.
C314383C01
1.385,0.25 1.698,0.448 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the 3 brake tubes to the valve body.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 5.BLEED CLUTCH LINE (for LHD)

Hide 47900 6.CHECK LOAD SENSING PROPORTIONING VALVE ASSEMBLY

Hide 47900 7.ADJUST LOAD SENSING PROPORTIONING VALVE ASSEMBLY