The door control with receiver ECU assembly receives signals from the door control transmitter. Then, the door control with receiver ECU assembly sends lock/unlock signals to all door lock motors.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When replacing the door control with receiver ECU assembly or door control transmitter, refer to the registration procedures.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>REGISTRATION
Check the power door lock operation.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
Each door locks and unlocks normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Move the door control transmitter in the vicinity of the door control with receiver ECU assembly.
Refer to Parts Location for the location of the door control with receiver ECU assembly.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>PARTS LOCATION
Press and hold either the lock or unlock transmitter switch for 1 second and check that the doors lock or unlock accordingly.
Wireless door lock control functions operate normally.
Check if electrical noise is the cause by moving the door control transmitter closer to the door control with receiver ECU assembly. Moving it closer will decrease the effects of electrical noise.
If the operation check can be performed normally, there is a high probability that electrical noise or a decrease in output from the door control transmitter is the cause of the malfunction. There is a high probability that electrical noise is the cause if the problem occurs only in a certain location or only during a certain time of day. Also, custom components may be causing electrical noise. If custom components are installed in the vehicle, remove them and perform the operation check again.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the system can be switched to rewrite mode or add mode, and that a recognition code can be registered.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>REGISTRATION
Recognition code can be registered.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the door control transmitter.
Click hereVehicle Interior>DOOR LOCK>DOOR CONTROL TRANSMITTER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the transmitter battery.
Click hereVehicle Interior>DOOR LOCK>DOOR CONTROL TRANSMITTER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector (to Door Control with Receiver ECU Assembly) |
Disconnect the door control with receiver ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L31-11 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L31-1 (ALTB) - Body ground | Always | 11 to 14 V |
| L31-2 (B) - Body ground | Always | 11 to 14 V |
| L31-3 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG