Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR(w/ ABS) › 2014.08–2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0138477 FRONT SPEED SENSOR(w/ ABS) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR(w/ ABS)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Other than areas where instructions are provided, use the same procedure for the LH and RH sides.



PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR LH

a.

Install the front speed sensor LH with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

·

While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

·

After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

·

When installing the sensor, do not twist the wire harness.




Hide 89516D 2.INSTALL SKID CONTROL SENSOR WIRE

a.

Install the 2 harness clamps with the 2 bolts.

Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)

NOTICE:
·

When installing the clamp, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




b.

Attach the connector clamp to the harness clamp.


c.

Connect the front speed sensor connector.


d.

for 1GR-FE:

Install the harness clamp with the bolt.

C271314C02
0.094,0.083 0.396,0.271 0.302,0.188 10 true *a 3.427,0.135 3.74,0.292 0.313,0.156 10 false *b
*a for LH *b for RH


Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)


e.

for 1HZ, 1VD-FTV:

Install the harness clamp with the bolt.

C271315C02
0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 3.417,0.063 3.729,0.219 0.313,0.156 10 false *b
*a for LH *b for RH


Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)


f.

Install the harness clamp with the bolt.

Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)

C267653C02
0.073,0.073 0.385,0.229 0.313,0.156 10 false *a 3.865,0.083 4.177,0.24 0.313,0.156 10 false *b
*a for LH *b for RH



g.

Install the harness clamp with the bolt.

Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)

C267654C02
0.104,0.063 0.323,0.229 0.219,0.167 10 false *a 3.469,0.083 3.708,0.24 0.24,0.156 10 false *b
*a for LH *b for RH



h.

Connect the connector.


Hide 3.INSTALL FRONT WHEEL