Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
3.REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING
| *1 | Disc Brake Pad Guide Pin |
| *2 | Pin Hold Clip |
| *3 | Front Disc Brake Anti-rattle Spring |
Remove the pin hold clip.
Hold down the front disc brake anti-rattle spring and remove the 2 disc brake pad guide pins.
Remove the front disc brake anti-rattle spring.
Do not remove the 2 disc brake pad guide pins without holding down the front disc brake anti-rattle spring. The front disc brake anti-rattle spring will eject with a force capable of causing injury.
04465 4.REMOVE FRONT DISC BRAKE PAD
Remove the 2 front disc brake pads from the disc brake cylinder assembly LH.
04945 5.REMOVE FRONT ANTI-SQUEAL SHIM KIT
Remove the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from each front disc brake pad.
47313A 6.DISCONNECT FRONT FLEXIBLE HOSE LH
Remove the union bolt and gasket and disconnect the front flexible hose LH.
47750 7.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 bolts and disc brake cylinder assembly LH.
43512 8.REMOVE FRONT DISC