Home › Brake › BRAKE (REAR) › REAR BRAKE (for Rear Disc Brake)
RM25T0E _54 Brake _029918 BRAKE (REAR) _0138483 REAR BRAKE(for Rear Disc Brake) G

BRAKE (REAR)  REAR BRAKE(for Rear Disc Brake)  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust or scoring.

If necessary, replace the disc brake cylinder and piston.


Hide 2.CHECK PAD LINING THICKNESS

a.
C312782

Using a ruler, measure the pad lining thickness.

Standard thickness:

10.0 mm (0.394 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the pad lining thickness is less than the minimum, replace the pad.

HINT:

Be sure to check the wear on the rear disc after replacing the brake pad with a new one.



Hide 3.CHECK REAR DISC BRAKE PAD SUPPORT PLATE

a.

Check the 4 plates as follows. If necessary, replace the plates.

i.

Use brake cleaner to clean the pad of the pad support plate and cylinder mounting contact surface. Inspect for deformation, cracks, rust and foreign matter that is difficult to remove.


ii.

Use brake cleaner to clean the pad support plate contact surface of the cylinder mounting. After installing the pad support plate to the cylinder mounting, inspect for looseness and deformation.


iii.

After installing the pad, check that the pad does not fall off easily (due to the spring force of the pad support plate being insufficient).



Hide 4.CHECK DISC THICKNESS

a.
C312783

Using a micrometer, measure the disc thickness.

Standard thickness:

18.0 mm (0.709 in.)


Minimum thickness:

16.0 mm (0.630 in.)


If the disc thickness is less than the minimum, replace the disc.


Hide 5.CHECK DISC RUNOUT

a.
C312784

Install the disc with the 5 hub nuts.

Torque:
131 N*m (1336 kgf*cm, 97 ft.*lbf)


b.

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.

Maximum disc runout:

0.15 mm (0.00591 in.)


If the disc runout is more than the maximum, check the rear axle shaft (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT>INSPECTION). If the rear axle shaft is normal, adjust the disc runout or grind the disc using an on-vehicle brake lathe.


c.

Remove the 5 hub nuts and disc.