Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR BRAKE SHOE (w/o ABS)
Using SST, remove the return spring from the rear brake shoe.
Remove the shoe hold down spring cup, shoe hold down spring, shoe hold down spring pin and rear brake shoe.
Remove the rear brake shoe and shoe tension spring.
2.REMOVE FRONT BRAKE SHOE (w/o ABS)
Remove the shoe hold down spring cup, shoe hold down spring, shoe hold down spring pin and front brake shoe.
Using pliers, disconnect the parking brake wire LH from the parking brake shoe lever.
47062 3.REMOVE PARKING BRAKE SHOE STRUT SET LH (w/o ABS)
Remove the parking brake shoe strut set LH from the front brake shoe.
Do not disassemble the strut set, and be careful not to damage or bend any of the components.
47430G 4.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER TENSION SPRING (w/o ABS)
Using SST, remove the rear brake automatic adjust lever tension spring.
47664 5.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER (w/o ABS)
Remove the E-ring and rear brake automatic adjust lever.
47612A 6.REMOVE PARKING BRAKE SHOE LEVER LH (w/o ABS)
Remove the C-washer and rear brake parking brake shoe lever LH.
7.REMOVE REAR SPEED SENSOR LH (w/ ABS)
47619 8.DISCONNECT PARKING BRAKE WIRE LH (w/ ABS)
| *1 | Wheel Cylinder Boot |
| *2 | Return Spring |
Using SST, remove the return spring from the rear brake shoe.
Do not damage the wheel cylinder boot.
Remove the shoe hold down spring cup, shoe hold down spring, shoe hold down spring pin and rear brake shoe.
Remove the rear brake shoe and shoe tension spring.
Remove the shoe hold down spring cup, shoe hold down spring, shoe hold down spring pin and front brake shoe.
Using pliers, disconnect the parking brake wire LH from the rear brake parking brake shoe lever.
47664 9.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER (w/ ABS)
Remove the rear brake automatic adjust lever tension spring and rear brake automatic adjust lever.
47612A 10.REMOVE PARKING BRAKE SHOE LEVER LH (w/ ABS)
Remove the parking brake shoe strut set LH from the front brake shoe.
Remove the C-washer and rear brake parking brake shoe lever LH.
47619 11.REMOVE PARKING BRAKE WIRE LH
Remove the parking brake wire LH from the parking brake bell crank LH.
47570 12.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH
Using a union nut wrench, disconnect the brake tube.
Remove the 2 bolts and rear wheel brake cylinder assembly LH.
13.REMOVE REAR WHEEL BRAKE CYLINDER CUP
Remove the 2 cylinder boots from the rear wheel brake cylinder assembly LH.
Remove the 2 pistons and compression spring.
Remove the 2 rear wheel brake cylinder cups from each piston.
47548R 14.REMOVE REAR BRAKE DRUM BLEEDER PLUG CAP
47547R 15.REMOVE REAR BRAKE DRUM BLEEDER PLUG
Remove the rear brake drum bleeder plug from the rear wheel brake cylinder assembly LH.
47625A 16.REMOVE PARKING BRAKE BELL CRANK LH
w/o ABS:
Remove the 2 tension springs from the parking brake bell crank LH.
w/ ABS:
Remove the tension spring from the parking brake bell crank LH.
Remove the clip and pin, then disconnect the No. 1 parking brake cable assembly.
Remove the 2 bolts and parking brake bell crank LH
Remove the C-washer and pin.
Remove the parking brake bell crank LH from the bell crank bracket.
Remove the bell crank boot from the parking brake bell crank LH.