Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
42312 1.REMOVE REAR AXLE SHAFT LH
42312C 2.REMOVE REAR AXLE SHAFT OIL SEAL LH
3.REMOVE REAR WHEEL
4.REMOVE REAR SPEED SENSOR LH (w/ ABS)
Remove the bolt and disconnect the rear speed sensor LH.
Be careful not to damage the speed sensor.
Prevent foreign matter from adhering to the speed sensor.
5.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH (for Disc Type)
Remove the 2 bolts and rear disc brake cylinder assembly.
42431 6.REMOVE REAR DISC (for Disc Type)
42403 7.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
42312E 8.REMOVE REAR AXLE HUB BOLT LH
42427 9.REMOVE REAR AXLE BEARING LOCK NUT
Remove the 2 lock nut set screws.
Using SST, remove the rear axle bearing lock nut.
42312F 10.REMOVE REAR AXLE SHAFT OUTER BEARING LH
Remove the rear axle lock nut plate LH and rear axle shaft outer bearing LH.
42440 11.REMOVE REAR AXLE HUB AND INNER BEARING ASSEMBLY LH
Remove the rear axle hub and rear axle shaft inner bearing LH.
42402E 12.REMOVE REAR AXLE HUB OIL SEAL LH
Using SST, remove the rear axle hub oil seal LH from the rear axle hub.
42312G 13.REMOVE REAR AXLE SHAFT INNER BEARING LH
Remove the rear axle shaft inner bearing LH from the rear axle hub.
14.REMOVE BEARING OUTER RACE
Using a brass bar and hammer, remove the 2 bearing outer races from the rear axle hub.
15.REMOVE REAR BRAKE SHOE (for Drum Type)
42311A 16.REMOVE REAR AXLE SHAFT OIL SEAL (for Drum Type)
Remove the rear axle shaft oil seal with the 4 bolts and 4 nuts.