Home › Drivetrain › R151F (MANUAL TRANSMISSION / TRANSAXLE) › TRANSMISSION CASE OIL SEAL
RM25T0E _52 Drivetrain _029903 R151F MANUAL TRANSMISSION / TRANSAXLE _0139327 TRANSMISSION CASE OIL SEAL A

R151F MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CASE OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 33131 2.REMOVE FRONT BEARING RETAINER

C313831

a.

Remove the 8 bolts.


b.

Using a brass bar and hammer, tap off the front bearing retainer from the manual transmission case.


Hide 33131A 3.REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL

a.
C314206C02
0.677,0.26 1.063,0.26 1.063,0.26 1.781,0.802 true 0.427,0.208 0.74,0.406 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver, pry out the front transmission bearing retainer oil seal.

NOTICE:

Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.


HINT:

Tape the screwdriver tip before use.



Hide 33131 4.INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL

a.
C314207N01
0.896,2.083 1.26,2.083 1.26,2.083 1.906,1.448 true 0.51,2.01 0.875,2.219 0.365,0.208 10 false SST

Using SST and press, drive in a new front transmission bearing retainer oil seal.

SST
09950-60010  (09951-00520, 09952-06010)
09950-70010  (09951-07150)

Standard Drive in Depth:

11.2 to 12.2 mm (0.4410 to 0.4803 in.)



b.

Apply MP grease oil to the lip of the front transmission bearing retainer oil seal.


Hide 33131 5.INSTALL FRONT BEARING RETAINER

a.

Remove any old FIPG material.


b.

Clean the contact surfaces of any residual FIPG material using non-residue solvent.


c.

Clean and degrease the 8 bolts and the installation holes in the transmission case.


d.
C315154C01
2.229,0.844 2.708,0.844 false 2.823,0.75 3.135,0.948 0.313,0.198 10 false *a
*a Seal Packing


Apply seal packing to the front bearing retainer, as shown in the illustration.

Seal Packing:

Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent.


NOTICE:
·

Assemble the parts within 10 minutes of application. Otherwise, the seal packing material must be removed and reapplied.

·

Apply seal packing in a continuous line (width 1.2 mm (0.0472 in.)) a long the sealing surface of the transmission case




e.

Apply adhesive to 2 or 3 threads of the bolts.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.



f.
C313831

Install the front bearing retainer to the manual transmission case with the 8 bolts.

Torque:
16.5 N*m (168 kgf*cm, 12 ft.*lbf)