Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR SIDE SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
09115 2.REMOVE JACK HANDLE ROD SUB-ASSEMBLY (for RH Side)
09114 3.REMOVE JACK HANDLE EXTENSION SUB-ASSEMBLY (for RH Side)
58796A 4.REMOVE JACK CLAMP HOOK (for RH Side)
73298B 5.REMOVE QUARTER TRIM BELT HOLE COVER LH
Remove the 2 screws and quarter trim belt hole cover LH.
73299 6.REMOVE NO. 2 QUARTER TRIM BELT HOLE COVER LH (w/ Rear No. 1 Seat)
Remove the 2 screws and No. 2 quarter trim belt hole cover LH.
87123 7.REMOVE HEATER KNOB (for Rear Heater)
62511 8.REMOVE QUARTER INSIDE TRIM BOARD RH (for RH Side)
62512 9.REMOVE QUARTER INSIDE TRIM BOARD LH
| *A | w/ Rear No. 1 Seat |
| *B | w/o Rear No. 1 Seat |
Using a clip remover, remove the 12 clips and quarter inside trim board LH.
73220 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly LH from the vehicle body.
Using a moulding remover D, detach the 2 claws and open the front seat outer belt shoulder anchor cover.
Loosen the bolt and disconnect the shoulder anchor of the front seat outer belt assembly LH from the vehicle body.
Remove the 2 bolts.
Detach the guide and remove the front seat outer belt assembly LH.