84222 1.INSTALL NO. 1 TRANSFER INDICATOR SWITCH (4WD POSITION AND L4 POSITION)
Install the No. 1 transfer indicator switch (4WD position).
Using SST, install the No. 1 transfer indicator switch (4WD position) and washer.
Connect the connector.
w/ ABS:
Install the No. 1 transfer indicator switch (L4 position).
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, install the No. 1 transfer indicator switch (L4 position) and washer.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.1811 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 21 N*m (214 kgf*cm, 15 ft.*lbf)
Connect the connector.
Install the manual transmission assembly.
Click hereDrivetrain>R151F (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION