Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
09115 1.REMOVE JACK HANDLE ROD SUB-ASSEMBLY (for RH Side)
09114 2.REMOVE JACK HANDLE EXTENSION SUB-ASSEMBLY (for RH Side)
58796A 3.REMOVE JACK CLAMP HOOK (for RH Side)
73298B 4.REMOVE QUARTER TRIM BELT HOLE COVER LH
Remove the 2 screws and quarter trim belt hole cover LH.
73299 5.REMOVE NO. 2 QUARTER TRIM BELT HOLE COVER LH
Remove the 2 screws and No. 2 quarter trim belt hole cover LH.
87123 6.REMOVE HEATER KNOB (for Rear Heater)
62511 7.REMOVE QUARTER INSIDE TRIM BOARD RH (for RH Side)
62512 8.REMOVE QUARTER INSIDE TRIM BOARD LH
Using a clip remover, remove the 12 clips and quarter inside trim board LH.
73370 9.REMOVE REAR SEAT OUTER 3 POINT TYPE BELT ASSEMBLY LH
Loosen the bolt and disconnect the floor anchor of the rear seat outer 3 point type belt assembly LH from the vehicle body.
Using a moulding remover D, detach the 2 claws and open the rear seat outer 3 point type belt shoulder anchor cover.
Tape the screwdriver tip before use.
Loosen the bolt and disconnect the shoulder anchor of the rear seat outer 3 point type belt from the vehicle body.
Remove the bolt.
Detach the 3 guides and remove the rear seat outer 3 point type belt assembly LH.