Home › Engine / Hybrid System › 1HZ (COOLING) › RADIATOR
RM25T0E _51 Engine / Hybrid System _029524 1HZ COOLING _0133827 RADIATOR G

1HZ COOLING  RADIATOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT LOCK PLATE

a.
A336189C01
1.865,1.563 2.24,1.563 false 1.625,0.292 1.781,0.146 1.781,0.146 1.958,0.146 false 2.823,0.688 2.948,0.688 2.948,0.688 3.052,0.813 false 2.625,0.594 2.823,0.792 0.198,0.198 10 false *1 2.271,1.458 2.469,1.656 0.198,0.198 10 false *2 1.99,0.031 2.188,0.229 0.198,0.198 10 false *1
*1 Lock Plate
*2 Radiator Core


Inspect the lock plate for damage.

If the sides of the lock plate groove are deformed, reassembly of the tank will be impossible. Correct any deformations with pliers.

Water will leak if the bottom of the lock plate groove is damaged or dented. Repair or replace it if necessary.

NOTICE:

The radiator assembly can only be recaulked twice. After the second time, the radiator core must be replaced.



Hide 16210 2.INSPECT FLUID COUPLING ASSEMBLY

a.

Remove the fluid coupling fan.

Click hereEngine / Hybrid System>1HZ (COOLING)>RADIATOR>REMOVAL


b.

Remove the 4 nuts and fan from the fluid coupling assembly.


c.

Turn the fluid coupling and check that the bearing moves smoothly and quietly.

If necessary, replace the fluid coupling assembly.


d.

Check that the fluid coupling assembly is not damaged and that no silicon oil leaks.

If necessary, replace the fluid coupling assembly.


e.

Install the fan to the fluid coupling assembly with the 4 nuts.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


f.

Install the fluid coupling fan.

Click hereEngine / Hybrid System>1HZ (COOLING)>RADIATOR>INSTALLATION