1.REMOVE MANUAL TRANSMISSION ASSEMBLY
33131 2.REMOVE FRONT BEARING RETAINER
Remove the 8 bolts.
Using a brass bar and hammer, tap off the front bearing retainer from the manual transmission case.
33131A 3.REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL
| *a | Protective Tape |
Using a screwdriver, pry out the front transmission bearing retainer oil seal.
Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.
Tape the screwdriver tip before use.
Protect the front bearing retainer with a cloth to prevent it from being damaged.
Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.
33131A 4.INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL
Using SST and a press, drive in a new front transmission bearing retainer oil seal.
15.4 to 16.2 mm (0.6063 to 0.6377 in.)
Install the front transmission bearing retainer oil seal in the correct direction.
Apply MP grease to the lip of the front transmission bearing retainer oil seal.
33131 5.INSTALL FRONT BEARING RETAINER
Remove any seal packing from the contact surfaces of the front bearing retainer and transmission case and clean the surfaces with a non-residue solvent.
Clean the 8 bolts and installation holes with a non-residue solvent.
| *a | Seal Packing |
Apply seal packing to the front bearing retainer as shown in the illustration.
Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent
Install the front bearing retainer within 10 minutes of application.
Make sure that foreign matter or oil does not adhere to the application surface.
Apply seal packing in the middle along the seal surface and inner side around the bolt holes.
Overlap the seal packing application start and end positions by 1 to 5 mm.
Using a plastic-faced hammer, lightly tap the front bearing retainer so that it fully contacts the transmission case.
Apply adhesive to 2 or 3 threads of the bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the front bearing retainer to the transmission case with the 8 bolts.
Uniformly tighten the bolts in several steps.
6.INSTALL MANUAL TRANSMISSION ASSEMBLY