89543 1.INSTALL FRONT SPEED SENSOR LH
Install the front speed sensor LH with the bolt.
Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
When installing the sensor, do not twist the wire harness.
2.INSTALL FRONT SPEED SENSOR RH
Install the front speed sensor RH with the bolt.
Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
When installing the sensor, do not twist the wire harness.
89516D 3.INSTALL SKID CONTROL SENSOR WIRE LH
Install the 2 harness clamps with the 2 bolts.
When installing the clamp, do not twist the wire harness.
Make sure the clamp rotation stopper touches the installation position.
Attach the connector clamp to the harness clamp.
Connect the front speed sensor connector.
Install the harness clamp with the bolt.
| *A | for Type A | *B | for Type B |
Install the harness clamp with the bolt.
| *A | for Type A | *B | for Type B |
Install the harness clamp with the bolt.
Connect the connector.
4.INSTALL SKID CONTROL SENSOR WIRE RH
Install the 2 harness clamps with the 2 bolts.
When installing the clamp, do not twist the wire harness.
Make sure the clamp rotation stopper touches the installation position.
Attach the connector clamp to the harness clamp.
Connect the front speed sensor connector.
Install the harness clamp with the bolt.
| *A | for Type A | *B | for Type B |
Install the harness clamp with the bolt.
| *A | for Type A | *B | for Type B |
for Type A:
Install the harness clamp with the bolt.
| *A | for Type A | *B | for Type B |
Connect the connector.
5.INSTALL FRONT WHEEL
6.CHECK SPEED SENSOR SIGNAL