Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY › 2016.08–2022.09
RM25T0E _58 Vehicle Interior _029929 SUPPLEMENTAL RESTRAINT SYSTEMS _0285167 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 73900 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B456533

Attach the 2 hooks to set the lower No. 1 instrument panel airbag assembly.


d.

Install the lower No. 1 instrument panel airbag assembly with 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



e.
B456535C01
2.552,2.635 2.354,2.198 2.354,2.198 2.135,2.198 true 1.969,2.104 2.281,2.26 0.313,0.156 10 false *a
*a Connector Lock


Connect the airbag connector and push in the connector lock.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



Hide 55480D 2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL