Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR › 2016.08–2022.09
RM25T0E _58 Vehicle Interior _029929 SUPPLEMENTAL RESTRAINT SYSTEMS _0285169 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 62316C 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:

Disconnect the rear side of the front door trim weatherstrip LH so that the center pillar garnish LH can be removed.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Single Cab)>REMOVAL


Hide 89835 6.REMOVE DOOR SIDE AIRBAG SENSOR LH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push down the housing lock and slide the CPA. (At this time, the airbag connector cannot be disconnected yet.)

B340847C03
4.26,1.01 4.625,0.594 4.625,0.594 4.979,0.594 true 3.354,1.698 3.594,1.698 3.594,1.698 3.729,1.229 true 3.021,0.438 3.333,0.438 3.333,0.438 3.646,0.76 true 5.031,0.49 5.344,0.646 0.313,0.156 10 false *a 3.177,1.594 3.49,1.75 0.313,0.156 10 false *b 2.844,0.323 3.146,0.531 0.302,0.208 10 false *c
*a Housing Lock *b CPA
*c CPA Upper Part - -



ii.

Push down the housing lock again and disconnect the airbag connector.

NOTICE:

Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.



iii.

After disconnecting the connector, check that the position of the housing lock is correct as shown in the illustration.

B340848C01
4.698,0.635 5.01,0.792 0.313,0.156 10 *a 1.49,1.885 1.802,2.042 0.313,0.156 10 *b 1.479,0.677 1.792,0.833 0.313,0.156 10 *a 4.74,1.885 5.052,2.042 0.313,0.156 10 *b
*a Incorrect *b Correct




d.
B456555

Remove the bolt.

NOTICE:

Loosen the bolt while holding the door side airbag sensor LH because the door side airbag sensor LH guide is easily damaged.



e.

Detach the guide and remove the door side airbag sensor LH.

NOTICE:

If the door side airbag sensor LH has been dropped, replace it with a new one.