Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System) › from 2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0287798 VEHICLE STABILITY CONTROL SYSTEM(w/o Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/o Pre-collision System)  C1337  Diameter of the Tire is not Uniform  


DESCRIPTION

The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must indicate the same speed.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1337 Diameter of the Tire is not Uniform The following occurs in 3 consecutive trips:
At a vehicle speed of 20 km/h (12 mph) or more, there is a difference of 20% or more in the average speed between the front wheels and rear wheels for 20 seconds or more.
·

Tire and wheel size

·

Tire deformation

·

Skid control rotor

·

Speed sensor

·

Speed sensor circuit

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System)>CALIBRATION


PROCEDURE

1.CHECK DTC
a.

Check if any DTCs relating to the speed sensor circuit are output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System)>DIAGNOSTIC TROUBLE CODE CHART

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Proceed to
DTC is not output
DTC is output




DTC is not output

2.CHECK TIRE SIZE

DTC is output

2.CHECK TIRE SIZE
a.

Check the tire size and condition of all 4 wheels.

OK:

All 4 tires are the same size and in the same condition.



Result:
Proceed to
OK
NG



OK

3.RECONFIRM DTC

NG

REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME SIZE AND IN THE SAME CONDITION

3.RECONFIRM DTC
a.

Clear the DTC.

Click here

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

b.

Turn the ignition switch off.


c.

Perform the following 3 times:

Turn the ignition switch to ON and start the engine, drive the vehicle at a speed of 30 km/h (19 mph) or more for at least 30 seconds, and then stop the vehicle and turn the ignition switch off.


d.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/o Pre-collision System)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Proceed to
DTC is output
DTC is not output




DTC is output

DTC is not output