The skid control ECU (brake actuator assembly) receives signals from the ECM via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1437 | Lost Communication with ECM | When voltage at terminal +BS is 10 to 17.4 V and vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to ECM continuously for 2 seconds or more. |
·
CAN communication system (skid control ECU to ECM)
·
Skid control ECU (brake actuator assembly)
·
ECM |
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.
Using the GTS, check for any momentary interruption in the wire harness and connector corresponding to the DTC.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| EFI Communication Open | EFI communication open detection | Normal or Error | Normal | Error: Momentary interruption |
| EFI Communication Invalid | ECM communication invalid detection | Normal or Error | Normal | Error: Invalid |
| Tester Display |
|---|
| EFI Communication Open |
| EFI Communication Invalid |
Perform the above inspection before removing the sensor and connector.
Normal (There are no momentary interruptions).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ VSC)>DIAGNOSIS SYSTEM
Check if the same DTC is recorded.
| Proceed to |
|---|
| DTC C1437 is not output |
| DTC C1437 is output |
| CAN communication system DTC is output |
DTC C1437 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC C1437 is output
CAN communication system DTC is output