Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.08
RM25T0E _51 Engine / Hybrid System _057930 CRUISE CONTROL _0287962 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using GTS:

·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



NOTICE:

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (INDICAT. SET)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. SET SET indicator light OFF or ON -
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. SET
50004 122 91
OK:

Cruise control SET indicator light turns ON/OFF.



Result:
Result
OK
NG



OK

2.READ VALUE USING GTS (SET/COAST SWITCH)

NG

2.READ VALUE USING GTS (SET/COAST SWITCH)
a.

Turn the cruise control system on using the cruise control main switch (ON-OFF).


b.

Drive at a speed between approximately 40 km/h or 25 mph and 200 km/h or 125 mph.


c.

Enter the following menus: Powertrain / Cruise Control / Data List.


d.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
SET/COAST Switch -SET switch signal OFF or ON ON: -SET switch on
OFF: -SET switch off
-
Powertrain > Cruise Control > Data List
Tester Display
SET/COAST Switch
50003 237 22

Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET switch). A
The cruise control SET indicator does not illuminate but the Data List item SET/COAST Switch changes according to the operation of the cruise control main switch (-SET switch). B
The cruise control SET indicator does not illuminate and the Data List item SET/COAST Switch does not change according to the operation of the cruise control main switch (-SET switch). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C