44110 1.INSTALL POWER STEERING GEAR ASSEMBLY
Install the power steering gear assembly with the 4 bolts and 4 nuts.
| *a | Torque Wrench Fulcrum Length |
Connect the steering gear steering gear outlet return tube and pressure feed tube assembly.
44.1 N*m (450 kgf*cm, 33 ft.*lbf)
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.1811 in.)) + torque wrench (fulcrum length of 255 mm (10.0394 in.)): 39.5 N*m (403 kgf*cm, 29 ft.*lbf)
45450 2.CONNECT STEERING RELAY ROD ASSEMBLY
Connect the pitman arm to the steering relay rod.
45203 3.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
| *a | Matchmark |
Align the matchmarks on the No. 2 steering intermediate shaft sub-assembly and power steering gear assembly.
Install the bolt.
Tighten the 2 bolts of the steering sliding yoke.
45636B 4.INSTALL INTERMEDIATE LINK JOINT PROTECTOR
Install the intermediate link joint protector with the bolt.
53736 5.INSTALL FRONT FENDER APRON SEAL RH
Install the front fender apron seal RH with the 4 clips.
6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17705 7.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
17881 8.INSTALL NO.1 AIR CLEANER HOSE
9.INSTALL FRONT WHEEL
10.ADD POWER STEERING FLUID
11.BLEED POWER STEERING FLUID
12.INSPECT POWER STEERING FLUID LEAK