89467B 1.INSTALL AIR FUEL RATIO SENSOR
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>INITIALIZATION
| *A | except Long Wheelbase |
| *B | for Long Wheelbase |
| *a | Torque Wrench Fulcrum Length |
Using SST, install the air fuel ratio sensor to the front No. 2 exhaust pipe sub-assembly.
44 N*m (449 kgf*cm, 32 ft.*lbf)
Replace with a new part if it is dropped or if it receives a strong impact.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)
Connect the air fuel ratio sensor connector.