Home › Engine / Hybrid System › 1VD-FTV (STARTING) › GLOW PLUG › from 2016.08
RM25T0E _51 Engine / Hybrid System _029900 1VD-FTV STARTING _0137001 GLOW PLUG G

1VD-FTV STARTING  GLOW PLUG  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 19850 1.CHECK GLOW PLUG ASSEMBLY

a.

Remove the No. 1 glow plug connector.

Click hereEngine / Hybrid System>1VD-FTV (STARTING)>GLOW PLUG>REMOVAL


b.
A391892

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Item Tester Connection Condition Specified Condition
w/ DPF Glow plug terminal - Body ground 20°C (68°F) 0.7 Ω or higher
w/o DPF Glow plug terminal - Body ground 20°C (68°F) Approximately 1.0 Ω


NOTICE:
·

Be careful not to damage the glow plug assembly, as this may cause an open circuit or shorten the life of the glow plug assemblies.

·

Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.

·

Clean any oil on the terminal and bakelite washer with a dry cloth.

·

Do not apply more than 11 V to the glow plug assembly, as this may cause an open circuit.



If the result is not as specified, replace the glow plug assembly.



c.

Install the No. 1 glow plug connector.

Click hereEngine / Hybrid System>1VD-FTV (STARTING)>GLOW PLUG>INSTALLATION