Home › Engine / Hybrid System › 1VD-FTV (STARTING) › GLOW PLUG › 2016.08–2022.09
RM25T0E _51 Engine / Hybrid System _029900 1VD-FTV STARTING _0137001 GLOW PLUG A

1VD-FTV STARTING  GLOW PLUG  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/ DPF:

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 19871 4.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.

Remove the 2 glow plug screw grommets and 2 nuts, and disconnect the 2 wire harnesses.


b.
A269587C01
0.083,0.125 0.271,0.292 0.188,0.167 10 false *A 0.083,2.427 0.354,2.615 0.271,0.188 10 true *B
*A Bank 1
*B Bank 2


Remove the 8 glow plug screw grommets, 8 nuts and 2 No. 1 glow plug connectors.


Hide 19850 5.REMOVE GLOW PLUG ASSEMBLY

a.
A269588C01
0.083,0.125 0.271,0.292 0.188,0.167 10 false *A 0.083,2.385 0.385,2.625 0.302,0.24 10 true *B
*A Bank 1
*B Bank 2


Using a 10 mm deep socket wrench, remove the 8 glow plug assemblies.

HINT:

Before removing the glow plug assembly, thoroughly clean off all dirt, sand, etc.