Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0135612 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  Brake Warning Light does not Come ON  


WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:
·

Before disconnecting the connector, make sure that there are no problems with the connection.

·

After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BRAKE WARNING LIGHT CIRCUIT)
a.

Turn the ignition switch off.


b.

Disconnect the L26 combination meter assembly connector.


c.

Disconnect the A15*1 or I85*2 brake master cylinder reservoir sub-assembly(brake fluid level warning switch) connector.

*1: for LHD

*2: for RHD



d.

for 1HZ and 1VD-FTV:

i.

Disconnect the I32 vacuum warning switch assembly connector.


ii.

Disconnect the L25 combination meter assembly connector.



e.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A15-1 (+)*1 or I85-1(+)*2 - L26-2 (SW) Always Below 1 Ω
A15-1 (+)*1 or I85-1(+)*2 or L26-2 (SW) - Body ground Always 10 kΩ or higher
I32-1*3 - L25-27 (BRL)*3 Always Below 1 Ω
I32-1*3 or L25-27 (BRL)*3 - Body ground Always 10 kΩ or higher


*1: for LHD

*2: for RHD

*3: for 1HZ and 1VD-FTV



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR