Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2017.01
RM25T0E _53 Suspension _062777 TIRE PRESSURE MONITORING _0306275 TIRE PRESSURE WARNING SYSTEM Y

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the tire pressure warning system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Interview the customer to confirm the trouble.

HINT:

It is important to collect as much specific information as possible from the customer to allow for a quick repair.


Result:
Proceed to
NEXT




NEXT

3.ADJUST TIRE PRESSURE*
3.ADJUST TIRE PRESSURE*
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

for Short Body with Tire Size 265/70R16:

Chassis > Tire Pressure Monitor > Data List
Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure
ID 5 Tire Inflation Pressure
50003 42 84,85,86,87,88

except Short Body with Tire Size 265/70R16:

Chassis > Tire Pressure Monitor > Data List
Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure
ID 5 Tire Inflation Pressure
50003 42 99,100,101,102,103

e.

Set all tire pressures to the specified value.

HINT:

Refer to the link as the procedure for adjusting the tire pressures differs depending on the temperature of the tires.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION



f.

Display "ID Tire Inflation Pressure" in the Data List and check that the tire pressure data matches the adjusted pressure amount.

HINT:

It takes a few minutes to display the updated tire pressure data.



g.

Perform initialization.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION

HINT:
·

The warning threshold value changes depending on the driving conditions during initialization. As a result, the tire pressure warning light may not turn off even if the tire pressure is adjusted to the specified pressure.

·

The tire pressure warning system illuminates the tire pressure warning light to warn the driver when any of the following conditions is met:

-

Due to the operation of the tire pressure warning reset switch, the tire pressure drops to approximately 75% or less of the tire pressure set during system initialization.

-

The tire pressure drastically decreases (approximately 20 kPa (0.2 kgf/cm2, 2.9 psi) or more within several minutes) to approximately 75% or less of the tire pressure* when the tires are warmed.

*: If initialization is performed and the vehicle is driven for a certain period of time, the tire pressure set during system initialization is adjusted and set to the tire pressure when the tires are warmed from the driving conditions.

HINT:

The tire pressure warning pressure (pressure at which the tire pressure warning light is illuminated) cannot be set to a value equal to, or less than, the lower limit threshold value*.

GTS Data List Item

*: "Threshold of Low-pressure (Lower Limit)"


The value that is approximately 75% of the set tire pressure during initialization*1 and the lower limit threshold value*2 are both displayed on the GTS, and the higher of the two values is set as the tire pressure warning threshold value.

*1: "Initial Threshold of Low-pressure"

*2: "Threshold of Low-pressure (Lower Limit)"



NOTICE:

If the tire pressure is decreased approximately 20 kPa (0.2 kgf/cm2, 2.9 psi) or more in order to adjust the tire pressure, even if the adjusted tire pressure is 75% or more than the tire pressure set during system initialization, the tire pressure warning light may illuminate if the tire pressure drops below 75% of the tire pressure set when the tires are warmed. In this case, perform initialization again.






Result:
Result Proceed to
Tire pressure warning light remains on A
Tire pressure warning light goes off B



A

4.CHECK FOR DTC*

B

9.CONFIRMATION TEST*
4.CHECK FOR DTC*
a.

Check for DTCs.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
DTCs are output A
DTCs are not output B




A

5.DTC CHART

B

6.PROBLEM SYMPTOMS TABLE
5.DTC CHART

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
NEXT



NEXT

7.CIRCUIT INSPECTION*
7.CIRCUIT INSPECTION*

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
a.

Repair or replace parts based on the diagnosis result.


Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST*
9.CONFIRMATION TEST*
a.

Check the Data List to confirm that the tire inflation pressure has been received.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST



c.

Confirm that the initialization has been completed.


Result:
Proceed to
NEXT



NEXT

END