Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o EGR System) › 2017.01–2017.09
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0309414 ECD SYSTEM(w/o EGR System) L

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR System)  PRECAUTION  


INITIALIZATION AND REGISTRATION


NOTICE:

When replacing the ECM and/or any other components in the following chart, perform the corresponding utility items.


HINT:

When the ECM and one or more other components are replaced at the same time, perform the following utility items by following the instructions shown on the GTS display, starting with the ECM.


Replacement Part Utility Item
Engine assembly Input Injector Compensation Code
(Click here)
Fuel supply pump assembly Supply Pump Initialization
(Click here)
Fuel injector Input Injector Compensation Code
(Click here)

NOTICE:

When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initializations/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.



INJECTOR COMPENSATION CODE


HINT:
·

Each fuel injector has different fuel injection characteristics. In order to optimize fuel injection performance, the ECM compensates for these differences by adjusting the fuel injection duration of each fuel injector according to its compensation code. Injector compensation codes are unique, 30- digit, alphanumeric values printed on the head portion of each fuel injector.

·

If an incorrect injector compensation code is input into the ECM, the engine may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.



a.

When an fuel injector is replaced, the injector compensation code must be input into the ECM.

Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR System)>REGISTRATION


b.
A141119C27
2.896,1.917 3.135,2.771 3.135,2.771 2.948,2.771 false 0.083,0.063 0.781,0.292 0.698,0.229 10 false *a 2.75,2.698 2.969,2.917 0.219,0.219 11 false *1
*1 Injector Compensation Code
*a Example:


When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM.

Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR System)>REGISTRATION



ENGINE DIFFICULT TO START, ENGINE STALLING, BLACK SMOKE EMITTED, ROUGH IDLING, EXCESSIVE ENGINE VIBRATION, ENGINE KNOCKING, LACK OF POWER OR HESITATION


a.

Check if the customer problem is described below. If so, refer to the appropriate troubleshooting section.

i.

The engine is difficult to start or stall.


ii.

Black smoke is emitted.


iii.

There is rough idling or excessive engine vibrations.


iv.

There is engine knocking or rattling.


v.

There is a lack of power or hesitation.




FOR USING GTS


CAUTION:

Observe the following items for safety reasons:

-

Read the GTS's instruction books before using the GTS.

-

Make sure that the GTS cable is not caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

-

When driving the vehicle for testing purposes using the GTS, two persons are required. One drives the vehicle and the other operates the GTS.