Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER (for Semi-long Body) › 2017.01–2022.09
RM25T0E _53 Suspension _062777 TIRE PRESSURE MONITORING _0310954 TIRE PRESSURE WARNING RECEIVER(for Semi-long Body) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for Semi-long Body)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR NO. 2 SIDE SEAT ASSEMBLY LH

Hide 64707D 6.REMOVE QUARTER TRIM JACK COVER SUB-ASSEMBLY

Hide 62640P 7.REMOVE QUARTER TRIM PANEL ASSEMBLY LH

Hide 8.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C370980

Remove the bolt.


b.

Detach the 2 guides to remove the tire pressure warning ECU and receiver.


c.

Disconnect the connector from the tire pressure warning ECU and receiver.