This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2780 | Push Switch / Key Unlock Warning Switch Malfunction | The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*). |
·
Harness or connector
·
Unlock warning switch assembly
·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2780 | Key SW |
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2780 is not output.
| Result | Proceed to |
|---|---|
| B2780 is not output | A |
| B2780 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Remove the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL
Inspect the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the L20 unlock warning switch assembly connector.
Disconnect the L30 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L20-2 - L30-3 (KSW) | Always | Below 1 Ω |
| L20-1 - Body ground | Always | Below 1 Ω |
| L20-2 - Body ground | Always | 10 kΩ or higher |
| L30-3 (KSW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG