To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used for the common rail system. Following the changes in the atmospheric pressure, the ECM corrects the fuel injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2226 | Barometric Pressure Circuit | Atmospheric pressure sensor malfunction (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P2228 | Barometric Pressure Circuit Low Input | Atmospheric pressure sensor malfunction (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P2229 | Barometric Pressure Circuit High Input | Atmospheric pressure sensor malfunction (1 trip detection logic) |
ECM | Comes on | DTC stored |
| DTC No. | Data List |
|---|---|
| P2226 |
·
Atmosphere Pressure
·
MAP |
| P2228 | |
| P2229 |
When the ignition switch is ON, the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.
Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:
Misfire
Combustion noise
Black smoke
White smoke
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P2226 P2228 P2229 |
Ignition switch to ON for 1 second |
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| P2226, P2228 or P2229 is output | A |
| P2226, P2228 or P2229 and other DTCs are output | B |
If any DTCs other than P2226, P2228 and P2229 are output, troubleshoot those DTCs first.
A
B