Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › 2017.09–2022.09
RM25T0E _58 Vehicle Interior _029929 SUPPLEMENTAL RESTRAINT SYSTEMS _0137999 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

Hide 84306 4.INSPECT SPIRAL CABLE SUB-ASSEMBLY

a.
B496276C01
1.469,1.479 1.813,1.802 0.344,0.323 1.167,3.198 0.813,2.74 true 0.708,2.448 0.323,1.802 true 1.229,3.135 1.542,3.292 0.313,0.156 10 false *a 0.156,1.677 0.469,1.833 0.313,0.156 10 false *c 1.479,1.49 1.677,1.667 0.198,0.177 10 true *b
*a Check Window
*b Matchmark
*c Top of Flat Cable U-turn


Check the check window shown in the illustration.

OK:

The connector is at the top.

The matchmarks are aligned.

The top of the flat cable U-turn can be checked from the check window.


NOTICE:

If the spiral cable sub-assembly cannot be centered, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable sub-assembly with a new one.



Hide 55480D 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 45287 6.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 7.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 8.REMOVE SPIRAL CABLE SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch on (IG).

·

Do not rotate the spiral cable with the battery connected and the ignition switch on (IG).



a.
B374336C01
0.865,4.208 0.865,4.448 0.865,4.448 1.177,4.448 true 1.219,4.344 1.531,4.5 0.313,0.156 10 false *1
*1 Slider


Slide the slider to release the lock, and then disconnect the airbag connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect each connector.


c.

Detach the 3 claws and remove the spiral cable sub-assembly.