47932A 1.INSTALL LOAD SENSING VALVE UNION BRACKET
Install the load sensing valve union bracket with the 4 bolts.
2.INSTALL LOAD SENSING PROPORTIONING VALVE
Install the load sensing proportioning valve with the 4 bolts.
Install the No. 1 load sensing shackle bracket to the rear axle housing with the 2 bolts.
3.CONNECT BRAKE TUBE
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the 3 brake tubes to the valve body.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
4.BLEED BRAKE SYSTEM
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/o VSC)>BLEEDING
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/o ABS)>BLEEDING
5.BLEED CLUTCH LINE
47900 6.CHECK LOAD SENSING PROPORTIONING VALVE ASSEMBLY
47900 7.ADJUST LOAD SENSING PROPORTIONING VALVE ASSEMBLY