Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (except 1GR-FE) › from 2019.09
RM25T0E _55 Steering _029920 POWER ASSIST SYSTEMS _0137065 VANE PUMP(except 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(except 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.

Coat a new O-ring with MP grease and install it to the vane pump assembly.


b.

Install the vane pump assembly with the 2 nuts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket to the pressure feed tube assembly.


b.
C421647C01
1.854,0.979 2.271,0.563 2.271,0.563 2.438,0.563 true 1.813,3.271 2.229,2.854 2.229,2.854 2.396,2.854 true 0.333,0.333 0.667,0.75 0.333,0.417 10 false *A 0.333,2.583 0.667,2.917 0.333,0.333 10 false *B 2.479,0.5 2.813,0.75 0.333,0.25 10 false *a 2.438,2.792 2.771,3.042 0.333,0.25 10 false *a
*A for 1VD-FTV
*B for 1HZ
*a Stopper


Connect the pressure feed tube assembly with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the tube touches the vane pump assembly body as shown in the illustration, then tighten the union bolt.



Hide 44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the No. 1 oil reservoir to pump hose to oil reservoir, and slide the clamp to secure it.


Hide 16470 4.INSTALL RADIATOR RESERVE TANK ASSEMBLY (for 1VD-FTV)

Hide 17705 7.INSTALL AIR CLEANER CAP SUB-ASSEMBLY (for 1VD-FTV)

Hide 9.BLEED AIR FROM POWER STEERING SYSTEM